Sabtu, 17 Juli 2010

Download Audi TT V-Flow Intake Install Instructions

https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEj6WOnXkOlxBrE6bUMbtMiWQioRly_QrJE49NOUUYuQCz5Qz_AKFwZSgmbYM_U-mRG4ulaIxoeKEKPaAzxBPdjcfIsr_4oVyocVnlq_-wt8-3hkmfl_H0mTeMtTFCh4ejTvcFsjxVnOmN9_/s400/senner-tuning-white-speed-audi-a5-30-tdi-01.jpg

Content Preview:

Audi TT V-Flow intake installation instructions ~ Start with your screwdriver and remove the three screws on the top of the stack. Then remove the lid of the car battery. Hold the lid on top of your MAF sensor to turn off. Put the lid off of the intake system. Using the screwdriver loosen the hose clamp on the MAF housing. You will notice a pipe with an angle of 90 degrees and a small plastic ring around the end of the part in the bottom of the factory air box. Firmly press the top and bottom of this cycle of compression and pull the hose from the factory air boxes. Remove the hose and drag back out of the work area Take the 10mm socket, extension, and the key. Remove the two screws holding the factory air box for the car. It is behind the negative battery terminal and the other to the opposite corner of the air box on the front of the driver side leg of the tower.Next remove the factory air box. The first half of immediate importance, and raise the engine up side closest to the fender. How to pick a side fender you should notice the large rubber pin slipped out of the hole in the fender liner, if the car has a fresh air channel was connected without the box that runs along the side inside the fender, you will notice that the box should be air separated from the fresh air duct. If your car has an air of this new channel, please, 10 mm, remove the nut that fixes the factory fresh air in the canal side of the fender. Then remove the piece of pipe.

Download Audi TT V-Flow Intake Install Instructions.Pdf:

[smartads]
Download file

Tidak ada komentar:

Posting Komentar