Audi A4 Brake Installation Guide for 1 ~ PREPARATION PLANT sure the vehicle is parked on the concrete and the handbrake is on. 2nd Place stops in front of and behind the rear tires. Consult the instructions in the third lifting and wheel removal proceedings before lifting the front of the vehicle. 4th Place the bow under the vehicle for stability. Remove the fifth wheel. 6th Place a hose line pressure on the brake line. This would minimize the loss of brake fluid. Use a key seventh 11mm Swedish, disconnect the brake caliper. Be aware that brake fluid may leak out of line again interrupted. 8th Disconnect the ABS sensor mount eyelet by pullingup. 9th Disconnect brake sensor mounting bracket. Pull the tab gently with a flathead screwdriver, turn right 90 degrees and lift. 10th Cut off the wire between the pad and Jack. Be sure to leave enough length of cable connector crimping son together. Band 1 / 8 "of insulation on the son and connect with a retractable cable as shown in photo below. It is recommended to protect the connection using shrink-wrap on round wire crimp 11. Insert dowels motion detector in the small opening on 12 feet. With a zipper equality included in the kit, the location of the zip tie Secure Socket over ABS also involves the right.
Download Audi A4 Brake Installation Manual.Pdf:
[smartads]
Download file
Tidak ada komentar:
Posting Komentar